Table of Contents
Advertisement
Figure 69. Removing the backplane
Next steps
1.
Install the
backplane.
Installing the backplane
Prerequisites
CAUTION:
You must note the slot number of each drive and temporarily label them before removal so that you can
replace them in the same slots.
NOTE:
Observe the routing of the cables on the chassis as you remove them from the system. You must route these
cables properly when you replace them to prevent the cables from being pinched or crimped.
Follow the safety guidelines listed in
Steps
1. Orient the drive cage so that the drive bays are facing down.
2. Place the backplane on the drive cage, aligning the screw holes on the backplane with the holes on the drive cage.
3. Using the Phillips #2 screwdriver, replace the screws to secure the backplane to the drive cage.
76
Installing and removing enclosure components
Safety
instructions.
Advertisement
Table of Contents
