Table of Contents
Advertisement
Figure 48. Removing the left linking board
Next steps
1.
Install the linking
board.
Installing the linking board
Prerequisites
1. Follow the safety guidelines listed in
Steps
1. Reconnect all the disconnected cables to the linking board.
2. Align the board with the standoff on the chassis and slide the board into place.
NOTE:
Ensure that the linking board cable connector is not folded or twisted while installing the sled, to avoid
damaging the linking board cable connector.
3. Using a Phillips #1 screwdriver, replace the screw on the linking board to secure the board in place.
60
Installing and removing enclosure components
Safety
instructions.
Advertisement
Table of Contents
