Table of Contents
Advertisement
Figure 70. Installing the backplane
Next steps
1. Reconnect all the disconnected cables.
2.
Install the drive cage into the
3. Follow the procedure listed in
Removing the backplane expander board
Prerequisites
NOTE:
To prevent damage to the drives and backplane, you must remove the drives from the system before removing
the backplane.
NOTE:
Observe the routing of the cable on the chassis as you remove them from the system. You must route these
cables properly when you replace them to prevent the cables from being pinched or crimped.
NOTE:
The backplane expander board is only available with 24 x 2.5-inch drives with NVMe configuration.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the drive
cage.
4. Disconnect all the cables from the backplane expander board.
enclosure.
After working inside your
enclosure.
Safety
instructions.
Before working inside your
enclosure.
Installing and removing enclosure components
77
Advertisement
Table of Contents
