Table of Contents
Advertisement
Steps
1. Using the Phillips #1 screwdriver, connect and secure the power cables to the midplane.
2. Place the midplane into the chassis.
3. Using the Phillips #1 screwdriver, tighten the screws that secure the midplane to the chassis.
Figure 52. Installing the right midplane
Next steps
1. Reconnect all the disconnected cables.
2.
Install the cooling fan
cage.
3.
Install the sleds into the
4. Follow the procedure listed in
Removing the left midplane
Prerequisites
NOTE:
Observe the routing of the cables on the chassis as you remove them from the system. Route these cables
properly when you replace them to prevent the cables from being pinched or crimped.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove all the sleds from the
4.
Remove the cooling fan
5. Disconnect all the connected cables.
Steps
1. Using the Phillips #1 screwdriver, remove the screws that secure the midplane.
2. Slide and lift the midplane out of the chassis.
3. Using the Phillips #1 screwdriver, remove the screws that secure the power cables to the midplane.
enclosure.
After working inside your
Safety
instructions..
Before working inside your
enclosure.
cage.
enclosure.
enclosure.
Installing and removing enclosure components
63
Advertisement
Table of Contents
