Table of Contents
Advertisement
Installing the 2.5 inch drive cage
Prerequisites
CAUTION:
To prevent damage to the drives and backplane, you must remove the drives from the system before
removing the backplane.
CAUTION:
You must note the number of each drive and temporarily label them before removal so that you can replace
them in the same locations.
Follow the safety guidelines listed in
Steps
1. Insert the drive cage into the enclosure, aligning the cage with the standoffs on the chassis.
2. Slide the drive cage toward the lock position.
3. Reconnect all the cables that were disconnected from the backplane.
4. Using the Phillips #1 screwdriver, secure the drive cage in place with screws.
Figure 57. Installing the 2.5-inch drive cage
Next steps
1. If applicable, reconnect all the cables that were disconnected from the linking board and chassis management board.
2.
Install the removed
drives.
3.
Install the fan
cage.
4.
Install the backplane
cover.
5. Follow the procedure listed in
Removing the 3.5 inch drive cage
Prerequisites
CAUTION:
To prevent damage to the drives and backplane, you must remove the drives from the system before
removing the backplane.
CAUTION:
You must note the slot number of each drive and temporarily label them before removal so that you can
replace them in the same slots.
NOTE:
Observe the routing of the cables on the chassis as you remove them from the system. You must route these
cables properly when you replace them to prevent the cables from being pinched or crimped.
Safety
instructions.
After working inside your
enclosure.
Installing and removing enclosure components
67
Advertisement
Table of Contents
