Table of Contents
Advertisement
List of Error Messages
Error message
#1 Command Not
Recognized
#2 Wrong Number
of Parameters
#3 Out of
Parameter Range
#5 Unknown
Character Set
#6 Position
Overflow
#7 Polygon
Buffer Overflow
#10 Output
Request Overlap
#11 I/O Command
Not Recognized
#12 Wrong I/O
Parameter
#13 Out of I/O
Parameter Range
#14 Too Many
I/O Parameters
#15 Error in I/O
Transmission
#16 I/O Buffer
Overflow
#17 Baudrate
Error
#18 I/O Error
Indeterminate
When an unrecognizable command is transmitted, that command is ignored.
When the number of parameters supported by a command is incorrect, that
command is ignored.
When a parameter value is outside that parameter's range, it is ignored.
When a character set code not included in the current character set is specified,
that character is ignored. Use [Character] on the menu to search for available
character set codes.
The overflow positions are ignored.
The overflow was ignored.
When executing an output request command, another output request command
was sent (only the first one received is effective).
When a device control command error has occurred, that command is ignored.
This error message occurs when an unsuitable device control command
parameter is specified (the initial value is set for the parameter which gener-
ated the error).
This error message occurs with overflow of a device control command
parameter.
This error message occurs when there are too many parameters or when not
terminated using a colon.
This error message occurs when a framing error, parity error, or overrun error
occurs during data transmission.
This error message occurs when the I/O buffer overflows. (Under such
circumstances, the plotter cannot perform plotting correctly.)
This error message occurs when there is an error with the setting for the rate of
transmission.
Turn off the power and then turn it on again before transmitting data from the
computer again.
An error other than those listed above has occurred.
38
Remarks
Advertisement
Table of Contents
