After Plotting; Care And Maintenance - Roland DPX-3700A User Manual

8 After Plotting

1) Remove the paper.
Press the
PAPER HOLD
2) Turn off the DPX.
Turn off the power to the DPX. If the plotter will not be used for a long time, the power cord should also be
unplugged.
3) Remove the pens.
Remove all pens from the pen stock. Cap and store the pens after use.

9 Care and Maintenance

• Be sure to turn off the power to the DPX before cleaning.
• Never attempt to oil or lubricate the mechanism.
Cleaning the Main Unit
If the unit becomes dirty, wipe gently using a cloth moistened with water or anhydrous alcohol.
Wipe the operation panel and display gently with a clean, soft cloth.
Cleaning the Drawing Board
Gently wipe with a soft cloth. If soiling is severe or the adsorptive force of the drawing board is weak
wipe gently using a cloth moistened with ethyl alcohol. The DPX use an electrostatic adsorption
drawing board, which must never come in contact with water, silicone cloth, neutral detergents, or
solvents, as these will irrevocably diminish the electrostatic adsorptive force.
Cleaning the Pen Cap Rubbers
Ink buildup on the pen cap rubbers may soil plots. Remove the pen cap rubbers and wash with water.
Replace them on the pen stock after allowing to dry completely (out of direct sunlight).
Cleaning the ejected lead stocker
When plotting with pencils, and pencil leads become short and do not feed out smoothly, these unneeded
leads are ejected to the ejected lead stocker located on the upper part of the pen stock. When the ejected
lead stocker becomes full, remove it from the DPX and dispose of the leads. (Refer to "Eject Lead
Stocker" on page 14.)
key to release the electrostatic adsorption and remove the paper
10
.