Table of Contents
Advertisement
13 Display Menus Flowchart
Power ON
Top menu
Main menu 1
Up/Down
When
carriage moves
towards the current
offset position.
When
carriage moves
towards the current
base point.
A
Normal
Mirror
is pressed, the pen
is pressed, the pen
B
+ Power ON
English
German
Japanese
French
Use
to select [ISO-**], [JIS-**], [ANSI-**] ([ANSI ARCH-**]),
[DIN], [USER 1], [USER 2] and [USER 3]. Use
a size. Press
to enable the setting. (Refer to page 6.)
Press
to clear the buffer and return to the top menu.
Press
to return to the top menu without clearing the buffer.
(Refer to page 8.)
Use
or
to select from 0 to 8.
Press
to enable the setting.
Use
or
to select a width from 0.18 mm to 1.00 mm.
Press
to enable the setting.
Use
or
to select a pen speed from 1 cm/s to 72 cm/s.
(When [HighSpeed] is selected using the [Plotting speed]: 1—80 cm/s)
Press
to enable the setting.
Use
or
to select a pen force from 10 gf to 500 gf
(in increments of 8 gf). Press
For minute adjustment, press
to select 0, -2, -4 or -6. Press
Use
or
to select a pen number.
Use
or
to select a pen group. (Refer to page 15.)
Use
or
to select a width from 5 cm to 50 cm.
Press
to enable the setting. (Refer to page 14.)
Press
19
or
to select
Use
to select to a pen number.
Use
to select to a pen number.
Use
to select to a pen number.
to enable the setting.
to select the pen, then press
to enable the setting.
Use
or
to
select a pen number.
to enable the setting.
(Refer to pages 25–32.)
Advertisement
Table of Contents
