Setting The Label - SATO VP208 Operator's Manual

On Batteries
● The battery is consumable. Even if the battery is fully
charged, operation time gradually becomes shorter. It is
the battery's characteristics, not an error or problem.
● The number of charges (about 500 times) and charging
time (about 4 hours) are for reference. They depend on
temperature around the charger or battery conditions.
● Charge the batteries in a place of +5 to +35°C.
Charging in high or low temperature may cause battery
deterioration.
● If the printer is too hot to too cold, keep the battery in a
place of +5 to +35°C for about 1 hour then charge the
battery. Charging between +10 and +30°C is
recommended.
● If the battery has not been used for a long period of
time, it may have self-discharged. Charge the battery
before use.
● Do not keep the battery fully charged. The battery may
become deteriorated.
● Do not keep the battery in high temperature. The
battery may become deteriorated.
Notes on Charging
● When the AC adapter is connected to a wall outlet with
the power off, the power is automatically turned on.
● If the button is pressed during charging, the
Power
error below is displayed.
Error 43 "CHARGING Wait till charging is complete."
● If the battery is removed during charging, the error
below is displayed.
Error 42 "NO BATTERY Please put battery."
● Even if AUTO POWER-OFF is set to "Enable," the
printer does not turn off during charging.
● In low battery status, printing and feeding cannot be
done during charging. Wait until the low-battery error is
released.
● During charging, the printer operates in normal mode.
However, if the printer has been set to start energy
saving mode, the printer operates in energy saving
mode even when charging.
● If a battery error occurs, do not use that battery.
Replace it.
● If a NO BATTERY error occurs with the battery installed
in the printer, replace the battery.
● If the printer is powered down during printing using a
deteriorated battery and cannot be restarted, replace
the battery.
● The power is turned off once charging is complete,
independently of the printer operation.

3. Setting the Label

1
. Open the top cover.
1) Push the cover open button .
2) Open the top cover .
2
. Set the label roll.
Set the label roll so that the surface touches the print
head.
If the label roll is difficult to be set, rewind the label roll
so that the ends of the roll becomes even.
3
. Close the top cover.
Close the cover until it clicks.
②
①
7