Removing Discs - Toshiba TECRA M2 User Manual

Removing discs

To remove the CD/DVD, follow the steps below and refer to the next figure.
Do not press the eject button while the computer is accessing the DVD-
ROM drive. Wait for the Slim Select Bay indicator to go out before you open
the drawer. Also, if the CD/DVD is spinning when you open the drawer, wait
for it to stop before you remove it
1. To pop the drawer partially open, press the eject button. Gently pull the
drawer out until it is fully opened.
■
When the drawer pops open slightly, wait a moment to make sure the
CD/DVD has stopped spinning before pulling the drawer fully open.
■
Turn off the power before you use the eject hole. If the CD/DVD is
spinning when you open the drawer, the CD/DVD could fly off the spindle
and cause injury.
2. The CD/DVD extends slightly over the sides of the drawer so you can
hold it. Hold the CD/DVD gently and lift it out.
3. Push the center of the drawer to close it. Press gently until it locks into
place.
TECRA M2
.
Removing a CD/DVD
Operating Basics
4-9