Toshiba TECRA M2 User Manual page 164

TOSHIBA Dual Pointing Device
If you are using a USB mouse, also refer to the USB section in this chapter
and to your mouse documentation.
Touch pad/AccuPoint
Problem
Either the Touch pad
or the AccuPoint does
not work.
On-screen pointer
does not respond to
pad operation
The mouse pointer
moves too fast or too
slow
Double-tapping
(Touch pad) or double-
clicking (AccuPoint)
does not work
USB mouse
Problem
On-screen pointer
does not respond to
mouse operation
TECRA M2
Procedure
Check the Device Select settings. Open the
Mouse properties icon and click the Dual Point
tab. Then click the Detail Setting button and click
the Device Select tab.
Check that the Touch pad is not selected.
Pressing Fn + F9 to enables TOSHIBA Dual
Pointing Device.
The system might be busy. If the pointer is shaped
as an hourglass, wait for it to resume its normal
shape and try again to move it.
Try changing the speed setting in the mouse
control utility.
1. Open the Control Panel, select the Mouse
icon and press Enter.
2. Click the Pointer Options tab.
3. Set the speed as instructed and click OK.
Try changing the double-click speed setting in the
mouse control utility.
1. Open the Control Panel, select the Mouse
icon and press Enter.
2. Click the Buttons tab.
3. Set the double-click speed as instructed and
click OK.
If problems persist, contact your dealer.
Procedure
The system might be busy. If the pointer is shaped
as an hourglass, wait for it to resume its normal
shape and try again to move it.
Make sure the mouse is properly connected to the
USB port.
Troubleshooting
9-15