Toshiba TECRA M2 User Manual page 138

Installing memory module (2nd memory)
Follow the steps below to install a memory module.
1. Save data, shutdown Windows and turn the power off.
2. Remove the AC adapter cable and other cables from the computer.
3. Close the display panel and turn the computer over. Remove the battery
pack.
4. Loosen a screw on the cover of the memory module slot.
5. Insert the memory module obliquely against the connector of the
memory module slot. Gently push the memory module until it is secured
in place.
■
Align the grooves of the memory module with the locking tabs of the
connector and insert the module into the connector firmly. If you find it
difficult to install the memory module, try to adjust the tabs of the
connector with a pen tip or other tools. Make sure to hold the memory
module with your fingers on the side edges (sides with grooves).
6. Reinstall the cover of the memory module slot. Fasten the screw you
loosened in Step 4.
Be sure that the cover is closed firmly.
TECRA M2
Removing the memory module cover
Installing a module
Optional Devices
8-11