Toshiba TECRA M2 User Manual page 195

Supported Frequency Sub-bands
Subject to the radio regulations that apply in the countries/regions, your
Wireless LAN card may support a different set of 5GHz / 2.4GHz channels.
Consult your Authorized Wireless LAN or TOSHIBA Sales office for
information about the radio regulations that apply in the countries/regions.
Wireless IEEE 802.11 Channels Sets (Revision B and G)
Frequency Range
Channel ID
1
2
3
4
5
6
7
8
9
10
11
12
13
*1 Factory-set default channels
*2 Refer to the sheet Approved Countries/Regions for use for the countries/regions.
that in which these channels can be used. When installing Wireless LAN cards, the
channel configuration is managed as follows:
■
For wireless clients that operate in a Wireless LAN Infrastructure, the
Wireless LAN card will automatically start operation at the channel
identified by the Wireless LAN Access Point, When roaming between
different access points the station can dynamically switch to another
channel if required.
■
For Wireless LAN cards installed in Wireless clients that operating in a
peer-to-peer mode, the card will use the default channel 10.
■
In a Wireless LAN Access Point, the Wireless LAN card will use the
factory-set default channel (printed in bold), unless the LAN
Administrator selected a different channel when configuring the Wireless
LAN Access Point device.
TECRA M2
2400-2483.5 MHz
2412
2417
2422
2427
2432
2437
2442
2447
2452
2457*
1
2462
2467*
2
2472*
2
Wireless LAN
F-3