Toshiba TECRA M2 User Manual page 25

TOSHIBA Dual Pointing Device
Built-in Touch pad
Built-in AccuPoint
Ports
Parallel
External monitor
Universal Serial Bus
(USB 2.0)
Docking interface
i.LINK™ (IEEE1394)
Infrared
Slots
PC card
SD card
TECRA M2
A Touch pad and control buttons in the palm rest
enable control of the on-screen pointer and
scrolling of windows.
This pointer control stick, located in the center of
the keyboard, provides convenient control of the
cursor.
Parallel printer or other parallel device
(ECP compatible).
15-pin, analog VGA port supports VESA DDC2B
compatible functions.
The computer has two Universal Serial Bus ports
that comply with the USB 2.0 standard, which
enables data transfer speeds 40 times faster than
the USB 1.1 standard. (The ports also support
USB 1.1.)
This port enables connection of an optional
Advanced Port Replicator III described in the
Options section.
This port enables high-speed data transfer
directly from external devices such as digital
video cameras. Some models are equipped with
a i.LINK port.
The serial infrared port is compatible with Infrared
Data Association (IrDA 1.1) standards. It enables
cableless 4 Mbps, 1.152 Mbps, 115.2 kbps,
57.6 kbps, 38.4 kbps, 19.2 kbps or 9.6 kbps data
transfer with IrDA 1.1 compatible external
devices.
The PC card slot accommodates two 5 mm Type
II cards or one Type III card.
This slot lets you easily transfer data from devices,
such as digital cameras and Personal Digital
Assistants, that use SD card flash-memory.
You can use memory module in this slot.
Introduction
1-7