Toshiba TECRA M2 User Manual page 6

Central Processing Unit ("CPU") Performance Disclaimer
CPU Performance in your computer product may vary from specifications
under the following conditions:
■
use of certain peripheral products
■
use of battery power instead of AC power
■
use of certain multimedia games or videos with special effects
■
use of standard telephone lines or low speed network connections
■
use of complex modeling software, such as high end computer aided
design application
■
use of computer in areas with low air pressure (high altitude >1,000
meters or >3,280 feet above sea level)
■
use of computer at temperatures outside the range of 5°C to 35°C (41°F
to 95°F) or >25°C (77°F) at high altitude (all temperature reference are
approximate).
CPU Performance may also vary from specifications due to design
configuration.
Under some conditions, your computer product may automatically shut-
down. This is a normal protective feature designed to reduce the risk of lost
data or damage to the product when used outside recommended
conditions. To avoid risk of lost data, always make back-up copies of data
by periodically storing it on an external storage medium. For optimum
performance, use your computer product only under recommended
conditions. Read additional restrictions under "Environmental
Requirements" in appendix A. Contact TOSHIBA Service and Support for
more information.
CE compliance
This product and the original options are designed to observe the related
EMC (Electromagnetic compatibility) and safety standards. However,
TOSHIBA should not guarantee that this product still observes these EMC
standards if options or cables not produced by TOSHIBA are connected or
implemented. In this case the persons who have connected / implemented
those options / cables have to assure that the system (PC plus options /
cables) still fulfils the required standards. To avoid in general EMC problems
following advice should be observed:
■
Only CE marked options should be connected / implemented
■
Only best shielded cables should be connected
TECRA M2 vi