1151SBD0104A
1-4. PARTS WHICH MUST NOT BE TOUCHED
(1) Screws
Purpose of Application of Red Paint
Red paint is applied to the screws which cannot be readjusted, set, or reinstalled in the field.
The basic rule is not to remove or loosen the screws to which red paint is applied. In addition, be advised
that, if two or more screws are designated as those which must not be touched on a single part, only
one representative screw may be marked with red paint.
(2) Variable Resistors on Board
Do not turn the variable resistors on boards for which no adjusting instructions are given in "ADJUST-
MENT."
(3) Other Screws
Two screws on the
Lens Rail
Two screws on the Mirror
Motor Unit
Two screws on the Lower
Pre-Image Transfer Guide Plate
1136D068AA
1136D070AA
D-5
1136D069AA