4 Replacement Procedures
4.14 Wireless LAN card
Removing the Wireless LAN card
To remove the Wireless LAN card, follow the steps below and refer to Figure 4-21.
1. Disconnect the wireless LAN antenna cables (black and white) from the Wireless
LAN card using an antenna coaxial cable disconnector.
2. Press the two latches outward to release the Wireless LAN card.
3. Disconnect the Wireless LAN card from the connector on the system board. Be
careful not to damage the connector.
Installing the Wireless LAN card
To install the Wireless LAN card, follow the steps below and refer to Figure 4-21.
1. Insert the Wireless LAN card into the connector on the system board.
2. Gently push the Wireless LAN card down until the latches on both sides are engaged.
3. Connect the wireless LAN antenna cables (black and white) to the connectors on the
Wireless LAN card.
4-32
[CONFIDENTIAL]
Wireless LAN card
Latch
Figure 4-21 Removing the Wireless LAN card
4.14 Wireless LAN card
Latch
Wireless LAN antenna cable
(black)
Wireless LAN antenna cable
(white)
PORTEGE R200 Maintenance Manual (960-519)