Toshiba Portege R200 Maintenance Manual page 273

4.27 Fluorescent Lamp
3. Removing the bezel
1) Place the module with the insulation sheet facing upwards.
2) Release three latches of the upper bezel and frame. Unhook four latches (two each
of both sides), peeling off the double-adhesive tape on the backside of the bezel
slowly and remove the bezel.
3) Release four latches of the bottom bezel and frame, and peel off the double-
adhesive tape on the backside of the bezel slowly. (The bezel with double-adhesive
tape will be reused.)
CAUTION: 1) When peeling off the latches and the double-faced tapes, be careful not to
damage the TAB.
2) When removing the bezel, do not break it and do not deform the bezel.
(The bezel with double-adhesive tape will be reused.)
Release four bezel latches.
(2)
Peel off the double-adhesive tape slowly.
Release two
(3)
bezel latches.
PORTEGE R200 Maintenance Manual (960-519)
Double adhesive
tape within the
bezel.
4-40 Replacing TMD fluorescent lamp(3)
4 Replacement Procedures
(3)
Release two bezel latches.
Release three bezel
(1)
latches.
Peel off the double-
adhesive tape slowly.
[CONFIDENTIAL] 4-57