Toshiba Portege R200 Maintenance Manual page 232

4 Replacement Procedures
Installing the HDD
To install the HDD, follow the steps below and refer to Figure 4-5 to 4-7.
1. Install the HDD to the HDD holder and stick two gaskets on the HDD unit.
CAUTION: 1. When replacing the HDD, be sure to stick gaskets on the HDD unit.
2. Stick two gaskets in the position shown below.
Gasket
2. Insert the HDD assembly into the connector CN4 on the HD FPC, holding the tab of
the HDD assembly.
3. Insert the HDD slot cover in the HDD slot slantingly and insert the projection into
the hole.
4. Push down the screw side of HDD slot cover and secure it with the following screw.
• M2×3S
CAUTION: When installing the HDD slot cover, be sure to insert the HDD slot
cover into the HDD slot slantingly and insert the projection into the
hole.
Projection
4-16 [CONFIDENTIAL]
S-FLAT HEAD screw
PORTEGE R200 Maintenance Manual (960-519)
4.5 HDD
x1