Toshiba Portege R200 Maintenance Manual page 234

4 Replacement Procedures
6. Disconnect the keyboard flexible cable from the connector CN3200 on the system
board and remove the keyboard.
Keyboard flexible cable
Installing the keyboard
To install the keyboard, follow the steps below and refer to Figure 4-8 and 4-9.
1. Place the keyboard face down on the palm rest.
2. Connect the keyboard flexible cable to the connector CN3200 on the system board.
3. Turn the keyboard face up and set it. Make sure that there is no gap between the
keyboard and the edge of the palm rest.
4. Secure the keyboard with the following screws.
• M2×2.5C S-FLAT HEAD screw
5. Install the keyboard holder while engaging the latches.
6. Close the display and turn the computer face down.
7. Secure the keyboard holder with the following screw.
•
4-18 [CONFIDENTIAL]
CN3200
Figure 4-9 Removing the keyboard
M2×4S BIND screw
x2
x1
PORTEGE R200 Maintenance Manual (960-519)
4.6 Keyboard