Attaching The Slide Rails To The Rack - H3C S6820 Series Installation Manual

Figure 23 Attaching the grounding cable to the primary grounding point on the S6820-32H
switch

Attaching the slide rails to the rack

The procedure is the same for attaching 1U and 2U slide rails to the rack. This section uses the 1U
slide rails as an example.
To attach the slide rails to the rack:
Identify the slide rail installation position in the rack.
1.
Install cage nuts (user-supplied) in the mounting holes in the rack posts.
2.
Align the screw holes in one slide rail with the cage nuts in a rear rack post, and use screws
3.
(user-supplied) to attach the slide rail to the post, as shown in
Repeat the preceding steps to attach the other slide rail to the other rear rack post.
4.
Keep the two slide rails at the same height so the slide rails can attach into the chassis rails.
Figure 24 Installing the 1U slide rails
15
Figure 24.