LEDs
System status LED
The system status LED shows the operating status of the switch.
Table 30 System status LED description
LED mark
SYS
QSFP28 port LED
Table 31 QSFP28 port LED description
LED status
Steady green
Flashing green
Steady yellow
Flashing yellow (3 Hz)
Off
SFP28 port LED
Table 32 SFP28 port LED description
LED status
Steady green
Flashing green
Steady yellow
Flashing yellow (3 Hz)
Off
Status
Description
Steady green
The switch is operating correctly.
Flashing green
The switch is performing power-on self test (POST).
Steady red
The system has failed to pass POST or has problems such as fan failure.
Helps you to locate the switch.
Flashing blue
To locate the switch in the rack, execute the locator blink blink-time
(3 Hz)
command. The LED then flashes blue at 3 Hz.
Off
The switch is powered off or has failed to start up.
Description
A transceiver module or cable has been correctly installed. The port has a link and
is operating at 100 Gbps.
The port is sending or receiving data at 100 Gbps.
A transceiver module or cable has been correctly installed. The port has a link and
is operating at 10 Gbps, 25 Gbps, or 40 Gbps.
The port is sending or receiving data at 10 Gbps, 25 Gbps, or 40 Gbps.
No transceiver module or cable has been installed or no link is present on the port.
Description
A transceiver module or cable has been correctly installed. The port has a link and
is operating at 25 Gbps.
The port is sending or receiving data at 25 Gbps.
A transceiver module or cable has been correctly installed. The port has a link and
is operating at 1/10 Gbps.
The port is sending or receiving data at 1/10 Gbps.
No transceiver module or cable has been installed or no link is present on the port.
58