Table of Contents
Advertisement
Figure2-20 Attaching the front mounting brackets and chassis rails to an S6116-48X switch
(front mounting brackets installed near the power supply side, rack mounting rail kit B,
narrow-spacing installation of chassis rails)
Figure2-21 Attaching the front mounting brackets and chassis rails to an S6116-48X (front
mounting brackets installed near the power supply side, rack mounting rail kit B,
wide-spacing installation of chassis rails)
Attaching the long/short slide rails to the rack
IMPORTANT:
M6 screws and cage nuts are used to attach the slide rails to the rack. Prepare M6 screws and cage
nuts yourself. As a best practice, use a torque of 30 kgf-cm (2.94 Nm) to fasten the M6 screws.
Before mounting the switch in the rack, you must attach slide rails to the rack.
The installation procedure is the same for different types of slide rails. The following procedure
attaches 1U long slide rails to the rack.
To attach the slide rails to the rack:
1.
Identify the slide rail installation position on the rack based on the switch installation position.
2.
Install cage nuts (user-supplied) in the mounting holes in the rack posts.
3.
Align the screw holes in one slide rail with the cage nuts in a rear rack post, and then use M6
screws (user-supplied) to attach the slide rail to the rack, as shown in Figure2-22.
2-17
Advertisement
Table of Contents
