Mounting The Switch In The Rack - H3C S6820 Series Installation Manual

Mounting the switch in the rack

This task requires two people.
To mount the switch in the rack:
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
1.
Verify that the mounting brackets and chassis rails have been securely attached to the switch
2.
chassis.
Verify that the slide rails have been correctly attached to the rear rack posts.
3.
Attach cage nuts (user-supplied) to the front rack posts and make sure they are at the same
4.
level as the slide rails.
One person performs the following operations:
5.
a. Supporting the bottom of the switch, aligns the chassis rails with the slide rails on the rack
posts.
b. Pushes the switch slowly to slide the chassis rails along the slide rails until the mounting
brackets are flush with the rack posts.
Another person uses screws (user-supplied) to attach the mounting brackets to the rack.
6.
To secure the switch in the rack, make sure the front ends of the slide rails reach out of the
chassis rails.
The rack-mounting procedures are the same for the S6820-56HF and S6820-32H switches. The
following figures use the S6820-32H switch as an example.
Figure 25 Mounting the S6820-32H switch in the rack (power module-side mounting position
for the mounting brackets)
16