Korg wavestate Owner's Manual page 81

Utility
Velocity curves
Convert Position = Pre-MIDI
Velocity (Keyboard to MIDI Out)
127
6
8
7
9
1
Soft
1 (Heavy), 2, 3: These are for heavy playing; most of the variation occurs in the upper velocity range.
4 (Normal): This is the default.
5, 6: These are for lighter playing.
7: This is for very light playing, at the expense of control in the middle of the range.
8 (Light): This curve produces the most uniform output, for when velocity sensitivity is not desired.
9 (Wide): This curve is designed for the heavier touch of external weighted keyboards.
Convert Position
[Pre-MIDI, Post-MIDI]
This setting controls how the Transpose and Velocity Curve settings work.You can think of these as a set of MIDI
effects processors, which can be used in one of two places within the wavestate.
Note: Regardless of the Convert Position, Transpose and Velocity Curve always apply when playing internal sounds
directly from the wavestate keyboard.
Pre-MIDI: This is the default. Transpose and Velocity Curve affect MIDI output.
Convert Position = Pre-MIDI
wavestate built-in keyboard
Post-MIDI: Transpose and Velocity Curve affect MIDI input. Use this to adjust response to an external MIDI
controller.
Post-MIDI also shifts Global and Performance Scales to match the Transpose setting—convenient for use with non-
equal-tempered scales. See also "Layer Transpose" on page 79.
Convert Position = Post-MIDI
Velocity (MIDI In to sound engine)
Max
5
Velocity
effect
4
3
2
1
Strong
Velocity
Curve
Transpose
Note Number changes
Transmitted
7
8
6
5
4
3
2
9
1
1
MIDI In
Scale
MIDI Out
77
127
Velocity
Curve = 4
No
Transpose generator
Received
Tone