Manual; Filter Mod - Korg wavestate Owner's Manual

Filter

Manual

When Mode is set to Manual, these parameters let you create your own mix of the filters.
You may wonder why Band Reject is not included here. This is because it's not a filter mode per se. Instead, it's created
by equal amounts of High Pass and Low Pass. Try it and see!
Dry
LP (Lowpass), HP (Highpass), BP (Bandpass),
[-100%...+100%]
These set the volume of the Lowpass, Highpass, Bandpass, and Dry signals, respectively. Negative values invert the
phase.

Filter Mod

These four parameters control the default modulation routings for Filter Cutoff. You can create additional routings as
desired; for more information, see "Adding Modulation Routings" on page 49.
LFO (INTENSITY)
[-142.00...+142.00]
This sets the amount of modulation from the Filter LFO, in semitones.
Envelope (ENV INTENSITY)
[-142.00...+142.00]
This sets the amount of modulation from the Filter Envelope, in semitones.
Vel->Env (VELOCITY)
[-142.00...+142.00]
This lets you use velocity to scale the amount of the Filter Envelope applied to Filter Freq, in semitones.
39