Table of Contents
Advertisement
Modulation
Filter and Pitch Env Velocity Intensity
Filter and Pitch Envelope Velocity Intensity cannot themselves be modulated.
Viewing and Editing Modulations
All user-created modulation routings can be viewed and edited on the Mods page.
Note: preset modulation routings, such as Filter Envelope modulation of Filter Cutoff or Pan LFO modulation of Pan,
are not shown here.
To view modulation routings:
1. Press MOD. The screen will change to the Mods page, which displays all of the modulation routings in the
current Program in a scrolling list.
Current Layer
Destination
2. Hold
ENTER
and press
Alternatively, you can cursor through each parameter, one by one; cursoring right from Int Mod Src goes to the Source
parameter of the next routing.
A scroll-bar on the right side of the display shows the current location in the list.
When you see the modulation routing that you'd like to edit:
3. Use
<
and
>
to select the Source, Intensity, and Int Mod Src (Intensity Mod Source) parameters.
4. Edit the Intensity as desired using the
5. To change the Source or Int Mod Src, select the parameter and then either move
Modulation Select popup appears.
In the Modulation Select popup, the modulation sources are organized into five groups: Controllers, Mod Knobs,
Generators, CC +, and CC +/-. The groups are shown in the left column, and the modulation sources are shown in the
right column.
6. Use
<
and
>
to move between the columns, and
most modulation sources can be selected by pressing their associated front-panel button (for Envelopes,
LFOs, and the Step Sequencer), or by holding down
wheel, or the Vector Joystick), playing a note on the keyboard (for Velocity), or sending MIDI data.
For information on the individual modulation sources, see "Modulation Sources" on page 52.
7. Press
ENTER
to confirm and exit the popup.
Filtering the modulation list
The list of modulations can be long. To view only the modulation routings related to a specific controller or section of
the synth, use the Show parameter on the Modulation List Info page. As a shortcut to open this parameter's popup
from anywhere in the UI, hold
1. Hold
MOD
and press <.
The Show In Mod List dialog appears.
# of routings to this
Show Filter
<
or
>
to scroll through the different routings.
VALUE
knob.
VALUE
MOD
and press <, as described below:
destination
Scroll Bar
to select items in the lists. Alternatively—and faster!—
ENTER
and moving a controller (such as a Mod Knob,
50
VALUE
or press ENTER. The
Advertisement
Table of Contents
