Table of Contents
Advertisement
Wave Sequencing 2.0
Pitch Lane Step
Step
See "Step" on page 23.
Transpose
[-24.00...+24.00 semitones]
This offsets the played note by up to two octaves, up or down. This also affects the index into the Multisample map,
potentially changing the sample selection, similar to transposing the entire keyboard.
Tune
[-12.00...+12.00 semitones]
This changes the tuning by up to one octave up or down. It does not affect the Multisample map.
Probability
See "Step Probability" on page 21.
Shape
The Shape Lane creates a contour over the duration of the step. It can affect volume (when Shape Controls Volume is
On) and/or the Pitch or Step Sequencer Lanes (when the respective Lane's Use Shape is On).
Shape Lane
Preset, Start, End, Loop Start, Loop End, Repeats
See "Front-Panel Lane Controls" on page 21.
Shape Controls Volume
[Off, On]
Off: Shape does not affect the Wave Sequence volume.
On: Shape directly controls the Wave Sequence volume.
Shape Lane Step
Step
See "Step" on page 23.
Shape
[List of shapes]
There are a large number of shapes to choose from, including ones with two, three, or four pulses.
Offset
[-1.00...+1.00]
This offsets the entire shape up or down. Offset works in conjunction with Level, below, similar to Offset and Amount
in Mod Processor "Gate" on page 62. For instance, if you want Shape to control volume, but don't want the volume to
drop all the way to silence, set both Offset and Level to +0.50.
Level
[-2.00...+2.00]
This varies the amplitude of the Shape. Negative values invert the shape.
Phase
°
[-180...+180
]
This controls the start point of the shape. For example, to start in the middle of the shape, set the Phase to +180°.
Prob (Probability)
See "Step Probability" on page 21.
27
Advertisement
Table of Contents
