Settings; Factory Settings; As-Address Dependent Image Activation; Pre-Adjusted Times - TCS Carus Origo CAI2010 Product Information

Factory settings

AS-address dependent image activation

If there are also front-door stations without cameras within a system with
CAI20x0 and video front-door stations, the image is not activated when
the CAI20x0 is called by an audio front-door station.
To guarantee this function, the possible AS addresses are separated into
two sections:
AS address
0 – 31*
AS address
as of 32*
*) The video AS-border can be configured with the configurator configo
Note:
The AS-addresses of the front-door stations have to be assigned via the Service Device.
For detailed information see section Service information in the TCS Installer 5 / 4 (Version 1) or TCS
Installer 7 / 4 (Version 2).
The device is equipped with am EEPROM which stores the following fac-
tory settings:
serial number for parallel call
function key

Pre-adjusted times

communication time
remaining conversation time after pressing
the door opener
image switch time
blinking period of the green LED, when
"video/speech channel is busy" when press-
ing the reverse key for speaking/hearing or
pressing the image button
internal standby time
floor door release time
timeout menu ring tone parameter
timeout menu image parameter
18

Settings

reserved for video front-
door stations
free, for front-door stations
without camera
the image is activated in
case of a door call (from
max. 16 video front-door
stations)
the image is not activated
in case of a door call
TM
.
1000000
light switch button
2 min
4 sec
80 sec
3 sec 3 x flashing
around 30
s
around 30 s
10 sec
10 sec