Figure 29
Mounting Plate Installed on Pole with Clamp Brackets
Item
Description
1
Pole clamp notch
2
Carriage bolts (4)
3
Pole clamps (2)
Install the Mounting Plate—Poles Larger than 4.5 Inches in Diameter
Required Materials
Mounting plate and steel straps included in
BAND-IT tool included in
Torque wrench
To install the mounting plate on a vertical pole that is larger than 4.5 inches (11.4 cm) in diameter (refer to
page
58):
1.
Assemble the straps and the mounting plate by threading the two steel straps through the band strap slots on the
mounting plate.
2.
Select a mounting location on the pole.
3.
Position the mounting plate on the pole as needed and tighten the straps around the pole.
Pole Mount Kit, page
Strap Tool Kit, page 53
57
1
2
3
50.
Figure 30 on