Table of Contents
Advertisement
Install the Mounting Plate—Through-Pole Mounting (Optional), page 58
Figure 27
Mounting Plate Details
1
2
3
Item
Description
1
Carriage bolt holes
2
Bracket mount holes
3
Clearance holes, 3/4 in.
4
Pole clamp notches
5
Steel band strap slots
Install the Mounting Plate—Poles Up to 4.5 Inches in Diameter
Required Materials
Mounting plate, carriage bolts, and clamp brackets included in
13-mm box-end socket wrench
To install the mounting plate on a vertical pole up to 4.5 inches (11.4 cm) in diameter (refer to
Figure 29 on page
1.
Select a mounting location on the pole and place the top and bottom pole clamp bracket (1) notches against the
pole.
2.
Place one of the clamp brackets on the opposite side of the pole, aligning the clamp bracket holes with the top two
carriage bolt holes on the mounting plate.
3.
Insert a carriage bolt (5) through each of the top two carriage bolt holes on the mounting plate and through the holes
in the clamp brackets.
4.
Position the each bolt in the clamp so that the bolt is next to the pole, as shown in
5.
To place the bracket hardware on each carriage bolt (see
Qty.
4
8
2
2
4
57:
Reverse angle
Pole Mount Kit, page
Figure 28 on page
55
4
5
4
50.
Figure 28 on page 56
Figure 28 on page
56.
56):
and
Advertisement
Table of Contents
