Table of Contents
Advertisement
a.
Place the washer (2) and then the split lock washer (3) on the back of each carriage bolt (5).
b.
Thread the hex nut (4) on each carriage bolt. Place the split-lock washer between the washer and the nut.
Figure 28
Carriage Bolt Hardware Assembly Details
1
2
3
6.
Hand tighten the hex nuts (do not overtighten).
7.
Repeat Step 3 through Step 6, installing the two bottom carriage bolts and the second clamp bracket at the bottom
of the mounting plate.
8.
Position the mounting plate and clamp brackets on the pole as needed before further tightening the carriage bolts.
9.
Use a socket wrench to evenly tighten all four carriage bolts to finish installing the mounting plate on the pole.
4
56
5
Advertisement
Table of Contents
