Table of Contents
Advertisement
6.
Follow these steps on the opposite side of the pole:
a.
Place a fender washer on the end of the bolt, and then a nut.
b.
Hand tighten the nut.
7.
Repeat Step 5 and Step 6 for the second bolt.
8.
Use a socket wrench to evenly tighten both bolts to finish installing the mounting plate on the wooden pole.
Figure 31
Mounting Plate Installed on Wooden Pole with Through Bolts
1
2
Item
Description
1
Wood pole
2
5/8-in. through bolts (2)
Attach the Mounting Bracket to the Mounting Plate
This section describes how to attach the mounting bracket to the mounting plate.
Assemble Bracket Hardware
Several of the procedures in this section require you to assemble the bracket hardware before installing the bracket. A
bracket hardware set consists of one bolt, one washer, one split lock washer, and one nut.
To assemble the bracket hardware:
1.
Slide the split lock washer (2) on the bolt (1).
2.
Slide the regular washer (3) on the bolt (1).
Place the split-lock washer between the regular washer and the bolt as shown in
59
Figure 32 on page
60.
Advertisement
Table of Contents
