Table of Contents
Advertisement
Figure 39
Assemble Bracket and Security Panel
3.
Swing the panel shut over the bracket, aligning the three screw holes on the panel with the corresponding holes on
the bracket.
4.
Insert the three security panel screws (included in the mounting bracket kit) and tighten using the Phillips screw
driver (see
Figure 40 on page
The router door captive bolt inside the door lock post is aligned over the bracket hole as shown in
page
66.
Note:
For clarity, the router is not shown here. During this procedure, the router is mounted in the bracket.
Figure 40
Security Panel Attached to Bracket with Included Screws
5.
Tighten the captive bolt (using 6-7 ft-lbs of torque) located inside the router door lock post (2 in
page
66), ensuring the bolt extends into the security bracket (3 in
65).
65
Figure 41 on page
66).
Figure 41 on
Figure 41 on
Advertisement
Table of Contents
