Attach The Mounting Bracket; Assemble Bracket Hardware - Cisco 1240 Hardware Installation Manual

Mounting Instructions
D E C . 2 0 1 1 — E F T R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
Figure 4-9
Item
1
2

Attach the Mounting Bracket

This section describes how to attach the mounting bracket to the mounting plate.

Assemble Bracket Hardware

Several of the procedures in this section require you to assemble the bracket hardware before installing
the bracket. A bracket hardware set consists of one bolt, one washer, one split lock washer, and one nut.
Take these steps to assemble the hardware:
Slide the split lock washer (
Step 1
Slide the regular washer (
Step 2
The split lock washer should be between the regular washer and the bolt as shown in
Cisco 1240 Connected Grid Router Hardware Installation Guide
4-12
Mounting Plate Installed on Wooden Pole with Through Bolts
Description
Wood pole
5/8-in. through bolts (2)
) on the bolt (
2
) on the bolt (
3
).
1
).
1
Chapter 4 Mounting the Router
Figure 4-10.
OL-12345-01