Electrical Requirements - Jackson CONSERVER XL-E Installation, Operation And Service Manual

SPECIFICATIONS
All electrical ratings provided in this manual are for reference only. Always refer to the machine data plate to get exact
electrical information for this machine. All electrical work performed on machines should be done in accordance with
applicable local, state, territorial, and national codes. Work should only be performed by qualified electricians and
authorized service agents.
Note that all electrical wiring used in this series of machines must be rated, at a minimum, for 212 °F (100 °C), and that only
copper conductors must be used.
Where applicable, heating element amperage draws have been adjusted for the assumed input voltage. The manufacturer
assumes incoming voltages will be either 115, 208, 230, or 460 Volts. Some heating elements used in the machines are rated
for other voltages, such as 240 Volts and 480 Volts. Always verify the amperage draw of the machine in operation when
sizing circuit protection.
Available Electrical Characteristics:
Conserver
®
Electrical Characteristics
VOLTS
PHASE
FREQ
WASH
MOTOR 10.0 A
AMPS
TOTAL
10.0 A
LOAD
07610-003-92-84-R
XL-E/XL HH
115 208
1 1
60 60
5.0 A
5.0 A

ELECTRICAL REQUIREMENTS

NOTICE
i
Conserver
Electrical Characteristics
VOLTS 208
PHASE 1
FREQ
60
WASH
MOTOR 5.0 A
AMPS
RINSE
HEATER 43.3 A 47.8 A
AMPS
TOTAL
48.3 A 52.8 A
LOAD
XL-E-LTH
®
230 208 230
1 3 3
60 60 60
5.0 A 5.0 A 5.0 A
25.0 A 27.7 A
30.0 A 32.7 A
7