Burner Identification/Verification - Heat & Glo SL-3X-IFT Installation Manual

F. Burner Identification/Verification
The burner may be accessed for identification and veri-
fication purposes. This task should be performed by a
qualified service technician. The logs and burner must be
removed to see these identification marks. Disconnect
the pilot from the burner before removal. See Figure 9.2
for burner identification chart. Notch patterns are located
on bottom side of burner.
DETAIL A
SL-3X-IFT
SL-5X-IFT
SL-7X-IFT
SL-9X-IFT
Figure 9.2 Burner Identification
Heat & Glo • SL-3X-IFT, SL-5X-IFT, SL-7X-IFT, SL-9X-IFT Installation Manual • 2472-980 Rev. Q • 3/20
NG /LP
53