Table of Contents
Advertisement
If you are unable to easily remove the panel, the panel clamps may be locked in the down position,
NOTE
or the panel in place sensor may be extended. Ask a service technician for assistance.
Other Errors
Other Errors
Other Errors
Other Errors
Do not dismiss error messages. Call a programmer or a service trained technician to assist you.
NOTE
N7280- - - - 90011
N7280
N7280
N7280
90011
90011 – – – – Rev A
90011
Rev A
Rev A
Rev A
2 2 2 2
Turn the X-ray Control key to the disable (0) position on
the operator control panel.
3 3 3 3
Unlock and open the top sliding access panels.
4 4 4 4
Reach in and remove the panel.
5 5 5 5
Close and lock all access panels.
6 6 6 6
Verify that the emergency stop buttons are in the up
position. If one is in the down position, call a service
technician to restart the system.
7 7 7 7
Verify that the Safety Interlocks green LED is lit on the
operator control panel.
8 8 8 8
Turn the X-ray Control key to the enable (1) position on
the operator control panel.
9 9 9 9
Press the X-ray Control on (1) button on the operator
control panel.
10
10 Verify that the X-ray on light is now red on the operator
10 10
control panel.
11
11 11
11 You are now ready to continue testing as before.
If an error occurs during testing, an appropriate message
will be displayed describing the nature of the problem, and
possible steps to take to fix it. (Figure 14 shows one of many
possible error messages). Specific directions on the next
steps to take are provided in the dialog box and must be
followed by the appropriate level of user and not ignored.
12
Operator Instructions
Operator Instructions
Operator Instructions
Operator Instructions
Advertisement
Chapters
Table of Contents
