Table of Contents
Advertisement
3 3 3 3 Operator Instructions
Operator Instructions
Operator Instructions
Operator Instructions
Startup the
Startup the System
Startup the
Startup the
Figure 4: Application login pop-up
N7280- - - - 90011
N7280
N7280
N7280
90011
90011 – – – – Rev A
90011
Rev A
Rev A
Rev A
System
System
System
The Medalist x6000 is operated through the use of a user
interface running on the system controller. Before starting
the system software, verify that the X-ray has been enabled.
Verify the Safety Interlocks are Closed
Verify the Safety Interlocks are Closed
Verify the Safety Interlocks are Closed
Verify the Safety Interlocks are Closed
On the operator control panel (see Figure 3) verify that the
Safety Interlocks green LED is lit. If it is not, call a service
technician to resolve the problem.
Verify the X X X X - - - - Ray
Verify the
Verify the
Verify the
Ray
Ray Has Been Enabled
Ray
Has Been Enabled
Has Been Enabled
Has Been Enabled
On the operator control panel (see Figure 3) verify that the
X-ray Control key is in the enabled position (1) and press
the X-ray Control enable button (1). Verify that the X-rays
red LED is lit.
Log on to Microsoft Windows XP
Log o
n to Microsoft Windows XP
Log o
Log o
n to Microsoft Windows XP
n to Microsoft Windows XP
Log on to Microsoft Windows using the Windows user name
and password provided by your administrator. When you
log on, the Medalist x6000 software starts automatically.
Log on to the Medalist x6000 User Interface
Log on to the Medalist x6000 User Interface
Log on to the Medalist x6000 User Interface
Log on to the Medalist x6000 User Interface
Log on to the Medalist x6000 user interface using the user
name and password provided by your administrator. Press
Login.
The system will perform a system startup. This may
take a few minutes. A progress indicator will be
displayed (see Figure 5).
5
Operator Instructions
Operator Instructions
Operator Instructions
Operator Instructions
Advertisement
Chapters
Table of Contents
