Ground The Equipment; Fuses; Do Not Operate In An Explosive Atmosphere; Do Not Operate Damaged Equipment - Agilent Technologies Medalist x6000 Operator Instructions Manual

Ground the Equipment

Ground the Equipment
Ground the Equipment Ground the Equipment

Fuses

Fuses Fuses Fuses

Do Not Operate in an Explosive Atmosphere

Do Not Operate in an Explosive Atmos
Do Not Operate in an Explosive Atmos Do Not Operate in an Explosive Atmos
Do Not Remove Equipment Do Not Remove
Do Not Remove Do Not Remove

Do Not Operate Damaged Equipment

Do Not Operate Damaged Equipment Do Not Operate Damaged Equipment Do Not Operate Damaged Equipment
Rev. A Rev. A Rev. A Rev. A
To minimize shock hazard, the instrument chassis and
cover must be connected to an electrical protective earth
ground. The instrument must be connected to the ac power
mains through a grounded power cable, with the ground
wire firmly connected to an electrical ground (safety
ground) at the power outlet. Any interruption of the
protective (grounding) conductor or disconnection of the
protective earth terminal will cause a potential shock
hazard that could result in personal injury.
This is a Safety Class 1 instrument (provided with a
protective earth terminal). An uninterruptible safety earth
ground must be provided from the main power source to the
product input wiring terminal or supplied power cable. The
protective features of this product may be impaired if it is
used in a manner not specified in the operation instructions.
For continued protection against fire, only the fuses with
the required rated current, voltage, and specified type
(normal blow, time delay, etc.) should be used. Go to the
Service section of the on-line help for the specifications for
each fuse. Do not use repaired fuses or short-circuited fuse
holders. To do so could cause a shock or fire hazard.
Do not operate the instrument in an explosive atmosphere
or the presence of flammable gases or fumes.
Equipment Cov Cover er er er
Equipment Equipment Cov Cov
Operating personnel must not remove instrument covers or
shields. Component replacement and internal adjustments
must be made only by service-trained personnel.
Under certain conditions, dangerous voltages may exist
even with the equipment switched off. To avoid dangerous
electrical shock, DO NOT perform procedures involving
cover or shield removal unless you are qualified to do so.
Whenever it is possible that the safety protection features
built into this product have been impaired, either through
physical damage, excessive moisture, or any other reason,
REMOVE POWER and do not use the product until safe
operation can be verified by service-trained personnel. If
necessary, contact your Agilent Technologies Service Center
for service and repair to ensure that safety features are
maintained.
v v v v
phere
phere phere
Legal Notices, Warranty and Safety Legal Notices, Warranty and Sa Legal Notices, Warranty and Sa Legal Notices, Warranty and Sa fety fety fety