Toro Groundsmaster 455-D Service Manual page 77

11. Apply a thin coat of Formetanch or Permatex No. 2
sealant to each end of the bearing housing at (Fig. 87,
Item a).
12. Apply MOLYKOTE G RAPID to the bearing surfaces
on the camshaft.
13. Install the camshaft (Item 3) with the DIST marking
at the timing gear end.
14. Install the camshaft bearing caps (Item 2) as shown
by cast-in markings.
15. Progressively tighten the bearing caps to 17.5 Nm
(13 ft-lb).
16. Install a new oil seal on tool TOR 976697 on the side
where the inner flange is the farthest away (Fig. 88).
17. Use a camshaft gear or pulley bolt to install the two
camshaft oil seals.
Groundsmaster 455-D
Page 3 - 59 Rev. B
Figure 87
TOR 976697
Figure 88
Engine