14. Install 1-1/4" diameter dust seal in seal gland bush
ing, flat or smooth side of dust seal must face down
towards bushing.
15. Install the quad-ring seal in seal gland bushing.
Smooth seal in place with your finger. Do not use any
seal that falls freely into pocket of bushing, see Fig. 60.
16. Install seal gland bushing over the spool end with a
twisting motion. Tap the bushing in place with a rubber
hammer. Make sure the bushing is flush against the
bearing race.
17. Install retaining ring in housing. After installing ring,
tap on ring end or pry with screwdriver around entire
circumference of ring to properly seat ring in groove.
®
Groundsmaster
455-D
Page 4 - 57
Figure 49
Figure 50
Repairs