21. Rotate spool and sleeve assembly until pin is paral
lel with port face. Install drive, make sure you engage
drive with pin, To assure proper alignment, mark drive
as shown (ref. B). Note relationship between slotted end
of drive to splined end of drive when marking.
22. Install 3" diameter seal in meter.
23. With seal side of meter toward spacer plate, align
star valleys (ref. A) on drive (ref. B). Note the parallel
relationship of reference lines A, B, C, and D. Align bolt
holes without disengaging meter from drive.
®
Groundsmaster
455-D
Page 4 - 59
Figure 53
Figure 54
Figure 55
Repairs