10/100/1000Base-T Autosensing Ethernet Port - H3C S6520X-SI Series Installation Manual

Figure 73 40G QSFP+ to SFP+ cable
1
(1) QSFP+ module
(3) SFP+ side pull tab
IMPORTANT:
You can use a QSFP-40G-SR4-MM850 or QSFP-40G-CSR4-MM850 transceiver module to
connect a QSFP+ port to four SFP+ ports. The QSFP+ transceiver module and SFP+ transceiver
modules to be connected must be the same in specifications, including central wavelength and fiber
type.
NOTE:
• As a best practice, use H3C QSFP+ transceiver modules, QSFP+ cables, or QSFP+ to SFP+
cables for the QSFP+ ports on the switch. The H3C QSFP+ transceiver modules, QSFP+ cables,
and QSFP+ to SFP+ cables available for the QSFP+ ports are subject to change over time. For
the most recent list of QSFP+ transceiver modules, QSFP+ cables, and QSFP+ to SFP+ cables
available for the QSFP+ ports, contact H3C Support or marketing staff.
• For more information about H3C QSFP+ transceiver modules, QSFP+ cables, and QSFP+ to
SFP+ cables, see H3C Transceiver Modules User Guide.

10/100/1000BASE-T autosensing Ethernet port

An LSPM4G4T6P interface module provides 10/100/1000BASE-T autosensing Ethernet ports.
Table 29 10/100/1000BASE-T autosensing Ethernet port specifications
Item
Connector type
Interface attributes
Max transmission distance
Transmission medium
Standards
2
Specification
RJ-45
•
•
100 m (328.08 ft)
Category-5 (or above) twisted pair cable
IEEE 802.3i, 802.3u, 802.3ab
(2) QSFP+ side pull tab
(4) SFP+ module
10/100 Mbps, full/half duplex, MDI/MDI-X, auto-sensing
1 Gbps, full duplex, MDI/MDI-X, auto-sensing
73
3
4