10/100/1000Base-T Autosensing Ethernet Port Led; 2.5G/1000/100Base-T Autosensing Ethernet Port Led - H3C S5170-EI Series Hardware Information

10/100/1000BASE-T autosensing Ethernet port LED

Table4-17 shows the description of 10/100/1000BASE-T autosensing Ethernet port LEDs on
switches that do not support the mode button.
Table4-17 10/100/1000BASE-T autosensing Ethernet port LED description
LED status
Steady green
Flashing green
Off
For switches that support the mode button, the 10/100/1000BASE-T autosensing Ethernet port
LEDs work in conjunction with the mode LED to indicate the operating state of the ports from
different aspects, as shown in Table4-18.
Table4-18 10/100/1000BASE-T autosensing Ethernet port LED description
Mode LED
(MODE) status
Steady green
(Link/Active mode)
Flashing green
(PoE mode,
available only for
PoE switches)
Flashing yellow
(IRF mode)

2.5G/1000/100BASE-T autosensing Ethernet port LED

Table4-19 2.5G/1000/100BASE-T autosensing Ethernet port LED description
Mode LED
(MODE) status
Steady green
(Link/Active mode)
Flashing green
Description
A link is present on the port.
The port is sending or receiving data.
No link is present on the port.
Ethernet port LED
status
Steady green
Flashing green
Off
Steady green
Flashing green (1 Hz)
Off
Steady green
Ethernet port LED
status
Steady green
Flashing green
Off
Steady green
Description
A link is present on the port.
The port is sending or receiving data.
No link is present on the port.
PoE power supply is normal.
•
The maximum PoE power provided by the port does
not meet the power requirement of the PD.
•
PoE power supply overcurrent, overvoltage, or
short-circuit has occurred.
•
The remaining power of the switch does not meet the
power supply requirement of the port.
The port is not connected to a PD or PoE is not enabled on
the port.
The autosensing Ethernet port LEDs on the switch work in
conjunction to indicate the IRF member ID of the switch.
For example, if the LEDs for ports 1 to 4 are steady green
and the other port LEDs are off, the IRF member ID of the
switch is 4.
Description
A link is present on the port.
The port is sending or receiving data.
No link is present on the port.
PoE power supply is normal.