Installing An Expansion Card - H3C S6520X-SI Series Installation Manual

The installation and removal procedures are similar for expansion cards. The following procedures
install and remove LSWM2QP2P (with an ejector lever) and LSPM6FWD (without an ejector lever)
expansion cards.

Installing an expansion card

Wear an ESD wrist strap. Make sure the strap makes good skin contact and is reliably
1.
grounded.
Use a Phillips screwdriver to remove the screw on the filler panel in the target expansion slot.
2.
Then remove the filler panel.
Keep the filler panel secure for future use.
Figure 35 Removing the filler panel from the target expansion slot
Unpack the expansion card.
3.
If the expansion card has an ejector lever, follow these steps to install it:
4.
a. Fully open the ejector lever, as shown by callout 1 in
b. Gently push the expansion card into the slot along the guide rails until the expansion card
has good contact with the chassis. See callout 2 in
c. Close the ejector lever, as shown by callout 3 in
d. Use a Phillips screwdriver to fasten the captive screw on the expansion card to secure the
card in the slot. See callout 4 in
If the expansion card does not have an ejector lever, follow these steps to install it:
5.
a. Gently push the expansion card into the slot along the guide rails until the expansion card
has good contact with the chassis. See callout 1
b. Use a Phillips screwdriver to fasten the captive screw on the expansion card to secure the
card in the slot. See callout 2
2
Figure
1
Figure
Figure
Figure
Figure 36.
Figure
37.
26
36.
36.
36.
37.