Installing The Switch In A 19-Inch Rack; Installation Method - H3C S6520X-SI Series Installation Manual

Installing the switch in a 19-inch rack

Installation method

Table 3 Installation method
Switch model
S6520X-16ST-SI
S6520X-24ST-SI
S6520X-10XT-SI
S6520X-16XT-SI
S6520X-18C-SI
S6520X-26C-SI
S6520X-26MC-SI
S6520X-26MC-UPW
R-SI
S6520X-26XC-UPW
R-SI
S6520X-54XC-UPW
R-SI
Figure 2 Procedure for rack-mounting the switch by using the front mounting brackets
Figure 3 Procedure for rack-mounting the switch by using the front and rear mounting
brackets
NOTE:
If a rack shelf is available, you can put the switch on the rack shelf, slide the switch to an appropriate
location, and attach the switch to the rack by using the mounting brackets.
Installation method
Using front mounting
brackets
Using front and rear
mounting brackets
5
Description
Attach the front mounting brackets to the sides of the
chassis, on a position near the port side or power module
side as needed.
•
Attach the front mounting brackets to the sides of
the chassis, on a position near the port side or
power module side as needed.
•
Install the rear mounting brackets based on the rack
depth.
If the rack depth is in the range of 429 to 595
mm (15.89 to 23.43 in), orient the brackets with
the wide flange inside the rack.
If the rack depth is in the range of 274 to 440
mm (10.79 to 17.32 in) and the distance from
the rear rack posts to the inner surface of the
cabinet door is larger than 153 mm (6.02 in),
orient the brackets with the wide flange outside
the rack.
•
If you are to install the PSR1110-56A power
modules for the switch, make sure the rack depth is
greater than 600 mm (23.62 in).