Mode Led; Management Ethernet Port Led; 1/10Gbase-T Autosensing Ethernet Port Led - H3C S6520X-SI Series Installation Manual

Table 36 Power module status LED description
LED mark
PWR1/PWR2

Mode LED

To show more information about the switch through the port LEDs, the switch provides a mode LED
(MODE) to indicate the type of information that the port LEDs are showing.
You can use the mode button to change the indication of the mode LED.
Table 37 Description for the mode LED
LED mark
MODE

Management Ethernet port LED

Table 38 Management Ethernet port LED description
Management Ethernet port LED (ACT/LINK) status
Steady green
Flashing yellow
Off

1/10GBASE-T autosensing Ethernet port LED

The S6520X-16ST-SI and S6520X-24ST-SI switches each provide a status LED for each
1/10GBASE-T autosensing Ethernet port to indicate their operating status.
Table 39 1/10GBASE-T autosensing Ethernet port LED description
1/10GBASE-T autosensing
Ethernet port LED status
Steady green
Flashing green
Steady yellow
Flashing yellow
Status Description
A power module is installed in the power module slot, and the power
Steady green
module is outputting power correctly.
A power module is installed in the power module slot, but the power
Steady yellow
module has failed or no power is input to the power module.
Off No power module is installed in the power module slot.
Status
Steady green
Flashing yellow
Description
The port LEDs indicate port rates.
The port LEDs indicates the IRF member ID
of the switch. For example, if the LEDs for
ports 1 to 5 are steady green and the other
LEDs are off, the IRF member ID of the
switch is 5.
Description
A link is present on the port.
The port is sending or receiving data.
No link is present on the port.
Description
A link is present on the port and the port is operating at 10 Gbps.
The port is sending or receiving data at 10 Gbps.
A link is present on the port and the port is operating at 1 Gbps.
The port is sending or receiving data at 1 Gbps
77