10/100/1000Base-T Autosensing Ethernet Port; 100/1000Base-X Sfp Port - H3C S5130-HI Series Installation Manual

NOTE:
USB devices from different vendors vary in compatibilities and drivers. H3C does not guarantee the
correct operation of USB devices from all vendors on the switch. If a USB device fails to operate on
the switch, replace it with one from another vendor.

10/100/1000BASE-T autosensing Ethernet port

Table 15 10/100/1000BASE-T autosensing Ethernet port specifications
Item
Connector type
Interface attributes
Max transmission distance
Transmission medium
Standards
1/10BASE-T autosensing Ethernet port
The LSWM2XGT2PM interface card provides 1/10BASE-T autosensing Ethernet ports.
Table 16 1/10BASE-T autosensing Ethernet port specifications
Item
Connector type
Interface attributes
Max transmission distance
Transmission medium
Standards

100/1000Base-X SFP port

The S5130-30F-HI switch provides 24 fixed SFP ports. The S5130-34C-HI switch provides eight
fixed SFP ports. You can install the 100 Mbps SFP modules in
transceiver modules in
Specification
RJ-45
•
10 Mbps, half/full duplex
•
100 Mbps, half/full duplex
•
1000 Mbps, full duplex
•
MDI/MDI-X, auto-sensing
100 m (328.08 ft)
Category-5 (or above) twisted pair cable
IEEE 802.3i, 802.3u, 802.3ab
Specification
RJ-45
1/10 Gbps, full duplex, MDI/MDI-X auto-sensing
•
Category-6 UTP—55 m (180.45 ft)
•
Category-6 STP—100 m (328.09 ft)
•
Category-6 SFTP—100 m (328.09 ft)
•
Category-6 and above twisted pair—100 m (328.09 ft)
Category-6 (or above) twisted pair cable
IEEE 802.3an, 802.3ab
Table 18 in the SFP ports.
70
Table 17 and the 1000 Mbps SFP