Hot Swap Of Vsp 8400 Ethernet Switch Module - Avaya 8000 Series Installing Manual

Note:
The levers are designed to stay in the position shown when the module is inserted into
the chassis. The levers are pulled upwards to extract the module.
If you have to remove a module, loosen the two screws that secure the module to the
chassis and rotate the extract levers up to eject the module from the chassis. Remove the
module, and then either install another module or replace the module bay cover.
Important:
You must have either a module or a module bay cover in each bay to ensure proper
ventilation. Leaving a module bay unpopulated or uncovered impairs the ability of the
fans to cool the chassis.

Hot swap of VSP 8400 Ethernet Switch Module

Hot swap feature is the ability to add, remove or replace system components without shutting down
the system and without interrupting the operation of the system when components are inserted or
removed. The VSP 8400 supports the hot swap of ESMs, power supply units and fan modules.
The following table explains the method of hot swapping in VSP 8400.
November 2016 Installing the Avaya VSP 8000 Series
Comments on this document? infodev@avaya.com
Ethernet Switch Module
29